 |
|
|
 |
Stevens PIF is a pre-assembled insulation fastener and plate used to mechanically attach approved Stevens insulation to approved substrates. Stevens PIF Fasteners are Factory Mutual (FM) approved. |
 |
Stevens #12 Insulation Fastener in combination with Stevens 2 7/8-in. (.071m) hex shaped Galvalume coated steel insulation plate is designed for the mechanical attachment of Stevens approved insulation board to the roof deck. |
 |
Stevens #14 All-Purpose Fastener is designed for mechanically attaching insulation and membrane. Stevens #14 All-purpose Fastener is designed for use with Stevens 2-in. (.051 m) Galvalume Barbed Metal Seam Plate or Stevens 2 7/8-in. (.073 m) hex insulation plate. |
 |
|
 |
Stevens ASAP Fastener & plate is an all-purpose #14 blue fastener pre-assembled with a 2-in. (.051 m) gray nylon locking plate. Designed to secure Stevens membranes to steel decks, wood plank and structural concrete (restrictions apply) |
 |
The Stevens CD-10 Concrete Fastener is blue, hammer-in, non-threaded fastener designed to secure insulation & Stevens membranes to structural concrete. |
 |
Stevens DeckGrip Fastener is a blue coated #15 fastener with a modified standard thread allowing it to be drilled into 18 to 26 gauge metal decking. The DeckGrip Plate is a 2-3/8-in. (.060 m) diameter Galvalume Steel seam plate. |
 |
 |
Stevens DeckGrip Reel Fast plates are designed for use with DeckGrip fasteners in mechanically fastened Stevens EP™ and Stevens EV® systems. The plates are collated on a reel using 2-mil polyethylene film as a banding. |
 |
Stevens Maxfast Fastener features a reduced drill point and deep buttress thread for increased withdrawal resistance. It is used in conjunction with the 3-inch (.076 m) diameter Maxfast Plate designed exclusively for use with Stevens’ Maxfast Fastener. |
 |
|
 |
The Stevens Purlin Fastener is designed for attaching Stevens roofing membranes to structural steel purlins (18 to 22 gauge) in standing seam metal roof retrofit applications. This fastener is designed for use with the Stevens 2-in. (50.8 mm) diameter metal Purlin Plate but can also be used with the Stevens DeckGrip 2 5/8-in. (66.7 mm) Seam Plate. |
 |
|
 |
Stevens SW Fastener & Plate kit features a double-edge drill point, a deep buttress single lead thread, and is used in conjunction with a specially designed metal plate called the Stevens SW plate. |
 |
© Stevens Roofing Systems/JPS Elastomerics 2007. All rights reserved. |